Read and follow all instructions and watch the videos below before installing Gutter Guard-All. If you have any questions feel free to contact us by email or call the 1-800-GUTTER 5. We would be happy to help.
View all of our videos here.
BEFORE YOU INSTALL:
Clean your gutters before installing these guards and make sure they are free flowing. Check the downspouts for obstructions, run water using a garden hose to wash away sand or roof grit and clean the gutters to the paint. Remove all baskets at the downspouts. Stick the hose in the downspouts and flush them out for about 3 minutes each. Make sure the gutters are level within 1/8 inch end to end.
TOOLS YOU WILL NEED: "NO SPECIAL TOOLS ARE NEEDED"
Installing the clip
Installing the Guard
Beginning at the same end of gutter, slide the guard with the large elongated holes under both layers of shingles on the bottom row nearest the gutter. Note: this side up on the guard, use caution not to break the shingles. Push the guard under the shingles until the front edge of the guard is flush with the front of the gutter. Trim the insertion tab only if needed. Cut and tuck the screen into the end of the gutter to keep the birds out, you can view this on our installation video. View the installation video
Finishing installing Guard
Now start snapping the two pieces together with pliers, then go on to the next piece and so on. Install the guard until you are within four feet of the other end then install from that end cutting and installing the same way as you installed the first end. View the installation video above
Note: These are general instructions, for exact detailed instructions please contact us. Updated instructions will be supplied to end users.
|THE GUTTER GUARD-ALL WARRANTY
These guards are to be free from defects in material and workmanship for a period of a minimum 25 year. This is also a NO PLUG warranty! If installation instructions are followed correctly and your gutters plug, we will pay to have your gutters cleaned.